Zefiro debuts at Metstrade with an electric boat with retractable foils

Motor boat

18/11/2026 - 08:54
advertising

Adidesign’s project combines a dual-mode hull with a modular platform for superyacht tenders, water taxis and short-range transfers.

A foiling boat’s draught matters at low speed, when entering a marina and when stowing it in a yacht garage. That is where Zefiro starts. Its foils fold completely within the hull profile, leaving the deck clear. The project will be presented in the Foiling Area at Metstrade, at RAI Amsterdam from 17 to 19 November 2026.

Developed by Adidesign with Costanza Brusa, Paolo Portinari and Mario Bonelli, Zefiro is designed for eight passengers plus the skipper. At low speeds it operates in displacement mode. According to the designers, at around 12 knots the foils generate enough lift to raise the hull. Inspired by the latest generation of America’s Cup boats, the hull geometry was developed using fluid dynamics simulations to improve stability at low speeds and ease the transition onto the foils.

The mechanism below deck

The retraction system uses an articulated pantograph that rotates without sliding components. The angle of incidence is adjusted by rotating the frame that supports the foils. The mechanism is housed below deck and, according to the team, can be serviced with the boat afloat. For a superyacht tender, folding the foils helps with two routine manoeuvres: coming alongside with a shallower draught and returning to a tender garage with side or stern access.

Once under way, lifting the hull reduces the area in contact with the water and therefore the drag. Zefiro relies on this principle to make electric propulsion more efficient. The project specifications list 60 kW of continuous power, a cruising speed of 20 knots, a top speed of 28 knots and a range of more than 70 nautical miles. The figures are based on a feasibility study. The material released for the show gives the team’s stated figures and leaves a practical question for anyone choosing a tender or running a shuttle: how does range change at full load or on a route with frequent stops and starts?

From yacht garage to scheduled service

The hull, foils, propulsion system and amidships batteries are integrated into a single structural platform. On that basis, Adidesign envisages layouts ranging from a custom tender to a water taxi, as well as boats for excursions and transfers between islands or resorts.

The requirements vary with the service. A yacht operator will look at the boat’s dimensions with the foils retracted and how easily it can be launched and recovered. Shuttle operators will also consider service frequency and the time available for recharging between shifts. These operations, as much as cruising at 20 knots, will show how versatile the platform is.

Filippo Ceragioli

©PressMare - All rights reserved

advertising
PREVIOS POST
MSC becomes Global Shipping Partner of Emirates Team New Zealand for the 38th America’s Cup
NEXT POST
HP Watermakers at Metstrade: rethinking the complete onboard water cycle